ABOUT THIS ITEM
Parade Flag Holder for Harley-Davidson’s FLT and FLH Models
- This parade flag holder bar is designed to fit all Harley-Davidson FLT and FLH models.
- The two small receiver tubes bolt onto the lower fender, and or saddlebag supports, and remain virtually unseen.
- The flag holder bar can then be installed or removed from the receiver tubes in seconds by removing two safety pins.
- Included is one flag holder socket.
- One or two more may be added (sold separately) to accommodate up to three flags.
- The sockets accommodate up to 1 1/4" poles, and are machined at 150 angle to their bases.
- They can be rotated and tightened to display your flags, angled to the rear, sides, diagonally or any combination of these.
- All components are machined from aircraft quality aluminum and steel, then polished to a flawless finish and triple chrome-plated
CUSTOMER REVIEWS
There are no community comments or ratings
Review This ItemPART APPLICATION
This item may be used with the following bikes:
-
HARLEY:
- » TOURING/DRESSER
CUSTOMER REVIEWS
On December 19, 2008 Harris aka Hawk Gardner wrote:
Just installed this on my '98 Road King, and really am impressed with the concept and quality. Worth the money after using all kinds of homemade flag rigs for PGR missions and a lot of shopping around. Very heavy stock, well fabricated. For any RK's with hard-bag guard rails, you will likely need the adapter kit sold separately. I had to, but still the total cost was under $200, and took about 2 hours total going at cautious, half-speed.
PART APPLICATION
This item may be used with the following bikes:
-
HARLEY:
- » TOURING/DRESSER
